Allison

Allison WTEC II Fault Code: 63 PID: SPN: 26 FMI...

My Store Admin

Subcode 26 is set when this function (Kickdown) is selected by calibration, the calibration designated input is active but not failed, and throttle position is less than the calibration value...

Allison WTEC II Fault Code: 63 PID: SPN: 26 FMI...

My Store Admin

Subcode 26 is set when this function (Kickdown) is selected by calibration, the calibration designated input is active but not failed, and throttle position is less than the calibration value...

Allison WTEC II Fault Code: 63 PID: SPN: 00 FMI...

My Store Admin

Code 63 00 is set when one of the two inputs for an input function Auxiliary Function Range Inhibit (Special) is in a different state (on or off) from the...

Allison WTEC II Fault Code: 63 PID: SPN: 00 FMI...

My Store Admin

Code 63 00 is set when one of the two inputs for an input function Auxiliary Function Range Inhibit (Special) is in a different state (on or off) from the...

Allison WTEC II Fault Code: 62 PID: SPN: 23 FMI...

My Store Admin

Main code 62 indicates the retarder temperature sensor or circuitry is providing a signal outside the usable range of the ECU. Retarder temperature sensor failed high (178?C; 352?F) Main code...

Allison WTEC II Fault Code: 62 PID: SPN: 23 FMI...

My Store Admin

Main code 62 indicates the retarder temperature sensor or circuitry is providing a signal outside the usable range of the ECU. Retarder temperature sensor failed high (178?C; 352?F) Main code...

Allison WTEC II Fault Code: 62 PID: SPN: 12 FMI...

My Store Admin

Main code 62 indicates the retarder temperature sensor or circuitry is providing a signal outside the usable range of the ECU. Retarder temperature sensor failed low (?45?C; ?49?F) Main code...

Allison WTEC II Fault Code: 62 PID: SPN: 12 FMI...

My Store Admin

Main code 62 indicates the retarder temperature sensor or circuitry is providing a signal outside the usable range of the ECU. Retarder temperature sensor failed low (?45?C; ?49?F) Main code...

Allison WTEC II Fault Code: 61 PID: SPN: 00 FMI...

My Store Admin

Main code 61 indicates the ECU has detected a hot fluid condition in the output retarder. Possible causes (but not all causes) for hot fluid are:1. Prolonged retarder use.2. Low...

Allison WTEC II Fault Code: 61 PID: SPN: 00 FMI...

My Store Admin

Main code 61 indicates the ECU has detected a hot fluid condition in the output retarder. Possible causes (but not all causes) for hot fluid are:1. Prolonged retarder use.2. Low...

Allison WTEC II Fault Code: 57 PID: SPN: 99 FMI...

My Store Admin

Main code 57 indicates failure of the range verification C3 pressure switch test. Range verification C3 pressure switch while in N2/N4. The test occurs when a range is commanded that...

Allison WTEC II Fault Code: 57 PID: SPN: 99 FMI...

My Store Admin

Main code 57 indicates failure of the range verification C3 pressure switch test. Range verification C3 pressure switch while in N2/N4. The test occurs when a range is commanded that...