CAT

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 61 PI...

The ECM detects the following conditions: •The engine coolant temperature is greater than 106 °C (223 °F) for the C-10 or C-12.•The engine coolant temperature is greater than 111 °C...

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 61 PI...

The ECM detects the following conditions: •The engine coolant temperature is greater than 106 °C (223 °F) for the C-10 or C-12.•The engine coolant temperature is greater than 111 °C...

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 59 PI...

The Engine Control Module (ECM) detects incorrect engine software . Probable Causes: 1) New ECM on vehicle, needs to be programmed2) Current ECM programmed incorrectly3) ECM Connection/harness

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 59 PI...

The Engine Control Module (ECM) detects incorrect engine software . Probable Causes: 1) New ECM on vehicle, needs to be programmed2) Current ECM programmed incorrectly3) ECM Connection/harness

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 58 PI...

This condition indicates that the SAE J1922 data link is not communicating correctly. Probable Causes: 1) ECM Connection/Harness2) Another device on the J1939 is causing problems (ABS, VORAD, Cab controller,...

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 58 PI...

The Engine Control Module (ECM) detects the following condition: •The parameter “Powertrain Data Link” must be programmed to J1939.•The ECM is unsuccessful in receiving a specific message from a device...

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 58 PI...

The Engine Control Module (ECM) detects the following conditions: •The ECM is unsuccessful in receiving a message from a J1939 source.•The ECM is not receiving a valid message from a...

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 58 PI...

The Engine Control Module (ECM) detects the following conditions: •The ECM is unsuccessful in receiving a message from a J1939 source.•The ECM is not receiving a valid message from a...

CAT 3406E (Prefix 1MM or 2WS) Fault Code: 56 PI...

Conditions Which Generate This Code: This condition indicates a customer specified parameter or a system configuration parameter that requires programming has not been programmed. Probable Causes: 1) New ECM on...