CAT

CAT 3126E Fault Code: 246-11 PID: Flash Code 00...

Indicates the Coolant Temperature is above 221°F (105°C) on 3116 engines and 224°F (107°C) on 3216 engines. Engine Monitoring must be programmed to WARNING or DERATE before this diagnostic code...

CAT 3126E Fault Code: 246-11 PID: Flash Code 00...

CAT 3126E Fault Code: 232-04 PID: Flash Code 21...

VSL Protection is less than 3000 rpm, and vehicle speed is constant when engine parameters indicate it should be changing.

CAT 3126E Fault Code: 232-04 PID: Flash Code 21...

VSL Protection is less than 3000 rpm, and vehicle speed is constant when engine parameters indicate it should be changing.

CAT 3126E Fault Code: 232-03 PID: Flash Code 21...

The ECM does not detect vehicle speed when conditions indicate vehicle speed should be present. This diagnostic code will not occur if programmed to 3000 rpm and desird engine pm...

CAT 3126E Fault Code: 232-03 PID: Flash Code 21...

The ECM does not detect vehicle speed when conditions indicate vehicle speed should be present. This diagnostic code will not occur if programmed to 3000 rpm and desird engine pm...

CAT 3126E Fault Code: 231-12 PID: Flash Code 00...

The Engine Control Module (ECM) detects the following conditions: •The ECM is unsuccessful in receiving a message from a J1939 source.•The ECM is not receiving a valid message from a...

CAT 3126E Fault Code: 231-12 PID: Flash Code 00...

The Engine Control Module (ECM) detects the following conditions: •The ECM is unsuccessful in receiving a message from a J1939 source.•The ECM is not receiving a valid message from a...

CAT 3126E Fault Code: 231-11 PID: Flash Code 58...

This condition indicates that the SAE J1939 data link is not communicating correctly. The parameter “Powertrain Data Link” must be programmed to J1939. The power train data link is designed...

CAT 3126E Fault Code: 231-11 PID: Flash Code 58...

This condition indicates that the SAE J1939 data link is not communicating correctly. The parameter “Powertrain Data Link” must be programmed to J1939. The power train data link is designed...

CAT 3126E Fault Code: 231-02 PID: Flash Code 58...

This condition indicates that the J1939 data link is receiving information from a specified device but the information is incomplete or corrupted. The parameter “Powertrain Data Link” must be programmed...