CAT

CAT 3126E Fault Code: 164-4 PID: Flash Code 15 ...

The customer parameter PTO configuration is programmed to remote throttle and the PTO On/Off switch is ON. The ECM is not receiving a correct PTO throttle signal

CAT 3126E Fault Code: 164-4 PID: Flash Code 15 ...

The customer parameter PTO configuration is programmed to remote throttle and the PTO On/Off switch is ON. The ECM is not receiving a correct PTO throttle signal

CAT 3126E Fault Code: 164-3 PID: Flash Code 15 ...

Indicates the battery circuit to the ECM has either an intermittent or low battery condition while the engine is running. If battery voltage disappears without returning, the ECM will not...

CAT 3126E Fault Code: 164-3 PID: Flash Code 15 ...

Indicates the battery circuit to the ECM has either an intermittent or low battery condition while the engine is running. If battery voltage disappears without returning, the ECM will not...

CAT 3126E Fault Code: 164-2 PID: Flash Code 15 ...

The Engine Control Module (ECM) detects the following conditions: •The injection actuation pressure is greater than 3 MPa (435 psi) for more than three seconds when the engine is off.•The...

CAT 3126E Fault Code: 164-2 PID: Flash Code 15 ...

The Engine Control Module (ECM) detects the following conditions: •The injection actuation pressure is greater than 3 MPa (435 psi) for more than three seconds when the engine is off.•The...

CAT 3126E Fault Code: 164-0 PID: Flash Code 17 ...

The acceleator pedal throttle position sensor supply voltage is higher than it should be.

CAT 3126E Fault Code: 164-0 PID: Flash Code 17 ...

The acceleator pedal throttle position sensor supply voltage is higher than it should be.

CAT 3126E Fault Code: 128-04 PID: Flash Code 44...

This diagnostic code is used only by GMT-560 applications. The ECM detects the following: •The Secondary Fuel Level signal voltage is below the acceptable range for more than 10 seconds....

CAT 3126E Fault Code: 128-04 PID: Flash Code 44...

This diagnostic code is used only by GMT-560 applications. The ECM detects the following: •The Secondary Fuel Level signal voltage is below the acceptable range for more than 10 seconds....

CAT 3126E Fault Code: 128-03 PID: Flash Code 44...

The ECM detects the following condition: •The Secondary Fuel Level signal voltage is above the acceptable range for more than 10 seconds. The fuel level sensors are OEM installed components...

CAT 3126E Fault Code: 128-03 PID: Flash Code 44...

The ECM detects the following condition: •The Secondary Fuel Level signal voltage is above the acceptable range for more than 10 seconds. The fuel level sensors are OEM installed components...