CAT
CAT 3126B Fault Code: 22-13 PID: Flash Code 42 ...
The Engine Control Module (ECM) detects the following conditions: •A timing calibration has never been performed on a new ECM or the timing is off by more than three degrees....
CAT 3126B Fault Code: 22-13 PID: Flash Code 42 ...
The Engine Control Module (ECM) detects the following conditions: •A timing calibration has never been performed on a new ECM or the timing is off by more than three degrees....
CAT 3126B Fault Code: 22-11 PID: Flash Code 42 ...
The Engine Control Module (ECM) detects the following conditions: •The primary speed/timing sensor and the secondary speed/timing sensor are off by more than three degrees.•A timing calibration has been successfully...
CAT 3126B Fault Code: 22-11 PID: Flash Code 42 ...
The Engine Control Module (ECM) detects the following conditions: •The primary speed/timing sensor and the secondary speed/timing sensor are off by more than three degrees.•A timing calibration has been successfully...
CAT 3126B Fault Code: 2-11 PID: Flash Code 72 S...
The Engine Control Module (ECM) detects one of the following items after attempting to operate the injector: •A low current condition (open circuit) exists in the wiring for the cylinder...
CAT 3126B Fault Code: 2-11 PID: Flash Code 72 S...
The Engine Control Module (ECM) detects one of the following items after attempting to operate the injector: •A low current condition (open circuit) exists in the wiring for the cylinder...
CAT 3126B Fault Code: 190-11 PID: Flash Code 34...
The ECM has been replaced and the Engine/Speed Timing Sensors have not been calibrated.
CAT 3126B Fault Code: 190-11 PID: Flash Code 34...
The ECM has been replaced and the Engine/Speed Timing Sensors have not been calibrated.
CAT 3126B Fault Code: 190-02 PID: Flash Code 34...
The Speed/Timing signal for Engine/Speed Timing Sensor #1 indicates rpm but the timing pattern is lost.
CAT 3126B Fault Code: 190-02 PID: Flash Code 34...
The Speed/Timing signal for Engine/Speed Timing Sensor #1 indicates rpm but the timing pattern is lost.
CAT 3126B Fault Code: 190-00 PID: Flash Code 35...
The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector...
CAT 3126B Fault Code: 190-00 PID: Flash Code 35...
The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector...