CAT

CAT 3126B Fault Code: 96-04 PID: Flash Code 00 ...

The Engine Control Module (ECM) detects the following condition: •The primary fuel level signal voltage is below the acceptable range for more than ten seconds. The fuel level sensors are...

CAT 3126B Fault Code: 96-04 PID: Flash Code 00 ...

The Engine Control Module (ECM) detects the following condition: •The primary fuel level signal voltage is below the acceptable range for more than ten seconds. The fuel level sensors are...

CAT 3126B Fault Code: 96-03 PID: Flash Code 00 ...

The Engine Control Module (ECM) detects the following condition: •The primary fuel level signal voltage is above the acceptable range for more than ten seconds. The fuel level sensors are...

CAT 3126B Fault Code: 96-03 PID: Flash Code 00 ...

The Engine Control Module (ECM) detects the following condition: •The primary fuel level signal voltage is above the acceptable range for more than ten seconds. The fuel level sensors are...

CAT 3126B Fault Code: 91-13 PID: Flash Code 28 ...

During the last 90 seconds of the idle shutdown mode after the Check Engine/Service Soon Lamp begins to flash, the brake or clutch pedal is depressed or released. NOTE: This...

CAT 3126B Fault Code: 91-13 PID: Flash Code 28 ...

During the last 90 seconds of the idle shutdown mode after the Check Engine/Service Soon Lamp begins to flash, the brake or clutch pedal is depressed or released. NOTE: This...

CAT 3126B Fault Code: 91-08 PID: Flash Code 32 ...

The Speed/Timing signal or Engine Speed/Timing Sensor #2 is lost and then returns (intermittent).

CAT 3126B Fault Code: 91-08 PID: Flash Code 32 ...

The Speed/Timing signal or Engine Speed/Timing Sensor #2 is lost and then returns (intermittent).

CAT 3126B Fault Code: 84-10 PID: Flash Code 36 ...

The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector...

CAT 3126B Fault Code: 84-10 PID: Flash Code 36 ...

The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector...

CAT 3126B Fault Code: 84-08 PID: Flash Code 36 ...

The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector...

CAT 3126B Fault Code: 84-08 PID: Flash Code 36 ...

The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector...